manny960
10-20-2008, 10:49 AM
Iv got a '95 960 and the driver seat has a bad motor. so it dosnt move forward and back. i decided to switch the to front seats so at least i can move my seat. i took da for lrg screws out but when i got da seats out i noticed a pin weilded in the middle of both rails that slides into a notch on da floor of the car. I cant seem to switch those seats now couse the pins are off buy a couple inchs from the middle of the rail for the left and right side. i guess my question is could i just cut these pins off or not? thx