| Created by OBDwiz - OCTech, LLC | www.obdsoftware.net |
| Name | Continuous | Available | Complete |
|---|---|---|---|
| Misfire | Yes | Yes | Yes |
| Fuel System | Yes | Yes | Yes |
| Components | Yes | Yes | Yes |
| Catalyst | No | Yes | No |
| Heated Catalyst | No | No | No |
| Evap System | No | Yes | No |
| Secondary Air System | No | No | No |
| AC Refrigerant | No | Yes | Yes |
| Oxygen Sensor | No | Yes | No |
| Oxygen Sensor Heater | No | Yes | No |
| EGR System | No | No | No |
| PID | Description | Value | Units |
|---|---|---|---|
| SAE 0x03 | Fuel system 1 status | 1 | |
| SAE 0x03 | Fuel system 2 status | 0 | |
| SAE 0x04 | Calculated load value | 80.39 | % |
| SAE 0x05 | Engine coolant temperature | 57.2 | F |
| SAE 0x06 | Short term fuel % trim - Bank 1 | 0 | % |
| SAE 0x07 | Long term fuel % trim - Bank 1 | 0 | % |
| SAE 0x0A | Fuel rail pressure (gauge) | 40.03 | psi |
| SAE 0x0B | Intake manifold absolute pressure | 28.94 | inHg |
| SAE 0x0C | Engine RPM | 0 | RPM |
| SAE 0x0D | Vehicle speed | 0 | MPH |
| SAE 0x0E | Ignition timing advance for #1 cylinder | 14 | deg |
| SAE 0x0F | Intake air temperature | 68 | F |
| SAE 0x10 | Mass air flow rate | 0 | lb/min |
| SAE 0x11 | Absolute throttle position | 21.57 | % |
| SAE 0x13 | Location of oxygen sensors | 3 | |
| SAE 0x15 | O2 voltage (Bank 1, Sensor 2) | 0 | V |
| SAE 0x15 | Short term fuel trim (Bank 1, Sensor 2) | 0 | % |
| SAE 0x1C | OBD requirements to which vehicle or engine is certified | 1 | |
| SAE 0x1F | Time since engine start | 0 | sec |
| SAE 0x21 | Distance traveled while MIL is activated | 0 | miles |
| SAE 0x2E | Commanded evaporative purge | 0 | % |
| SAE 0x2F | Fuel level input | 83.53 | % |
| SAE 0x30 | Number of warm-ups since DTCs cleared | 0 | |
| SAE 0x31 | Distance traveled since DTCs cleared | 40721.56 | miles |
| SAE 0x33 | Barometric pressure | 29.53 | inHg |
| SAE 0x34 | O2 sensor lambda wide range (current probe) (Bank 1, Sensor 1) | 1 | |
| SAE 0x34 | O2 sensor current wide range (Bank 1, Sensor 1) | 0 | mA |
| SAE 0x3C | Catalyst temperature (Bank 1 Sensor 1) | 56.66 | F |
| SAE 0x42 | Control module voltage | 11.99 | V |
| SAE 0x43 | Absolute load value | 12.94 | % |
| SAE 0x44 | Fuel/Air commanded equivalence ratio | 1 | |
| SAE 0x45 | Relative throttle position | 19.61 | % |
| SAE 0x46 | Ambient air temperature | 55.4 | F |
| SAE 0x47 | Absolute throttle position B | 37.25 | % |
| SAE 0x48 | Absolute throttle position C | 74.12 | % |
| SAE 0x49 | Accelerator pedal position D | 7.06 | % |
| SAE 0x4A | Accelerator pedal position E | 8.24 | % |
| SAE 0x4C | Commanded throttle actuator control | 19.61 | % |
| Aux 0x00 | Input voltage read by the scan tool | 12.1 | V |
| Sensor | Available |
|---|---|
| Bank 1 - Sensor 1 | Yes |
| Bank 1 - Sensor 2 | Yes |
| Bank 1 - Sensor 3 | No |
| Bank 1 - Sensor 4 | No |
| Bank 2 - Sensor 1 | No |
| Bank 2 - Sensor 2 | No |
| Bank 2 - Sensor 3 | No |
| Bank 2 - Sensor 4 | No |
| Component | Description | Value | Minimum | Maximum | Units | Result |
|---|---|---|---|---|---|---|
| $01 - Exhaust Gas Sensor Monitor Bank 1 – Sensor 1 | TID $82 - Manufacturer Defined | 0 | 0 | 0 | Incomplete | |
| $02 - Exhaust Gas Sensor Monitor Bank 1 – Sensor 2 | TID $81 - Manufacturer Defined | 0 | 0 | 0 | Incomplete | |
| $02 - Exhaust Gas Sensor Monitor Bank 1 – Sensor 2 | TID $80 - Manufacturer Defined | 0 | 0 | 0 | Incomplete | |
| $21 - Catalyst Monitor Bank 1 | TID $83 - Manufacturer Defined | 0 | 0 | 0 | Pass | |
| $3B - EVAP Monitor (0.040”) | TID $84 - Manufacturer Defined | 0 | 0 | 0 | Pass | |
| $3C - EVAP Monitor (0.020”) | TID $84 - Manufacturer Defined | 0 | 0 | 0 | Pass | |
| $3D - Purge Flow Monitor | TID $85 - Manufacturer Defined | 0 | 0 | 0 | Pass | |
| $41 - Exhaust Gas Sensor Heater Monitor Bank 1 – Sensor 1 | TID $86 - Manufacturer Defined | 0 | 0 | 32767 | Incomplete | |
| $42 - Exhaust Gas Sensor Heater Monitor Bank 1 – Sensor 2 | TID $86 - Manufacturer Defined | 0 | 0 | 32767 | Incomplete | |
| $81 - Fuel System Monitor Bank 1 | TID $87 - Manufacturer Defined | 0 | 0 | 0 | Pass | |
| $A1 - Misfire Monitor General Data | TID $0B - EWMA (Exponential Weighted Moving Average) misfire counts for last ten (10) driving cycles | 0 | 0 | 0 | counts | Pass |
| $A2 - Misfire Cylinder 1 Data | TID $0B - EWMA (Exponential Weighted Moving Average) misfire counts for last ten (10) driving cycles | 0 | 0 | 65535 | counts | Pass |
| $A2 - Misfire Cylinder 1 Data | TID $0C - Misfire counts for last/current driving cycles (calculated, rounded to an integer value) | 0 | 0 | 0 | counts | Pass |
| $A3 - Misfire Cylinder 2 Data | TID $0B - EWMA (Exponential Weighted Moving Average) misfire counts for last ten (10) driving cycles | 0 | 0 | 65535 | counts | Pass |
| $A3 - Misfire Cylinder 2 Data | TID $0C - Misfire counts for last/current driving cycles (calculated, rounded to an integer value) | 0 | 0 | 0 | counts | Pass |
| $A4 - Misfire Cylinder 3 Data | TID $0B - EWMA (Exponential Weighted Moving Average) misfire counts for last ten (10) driving cycles | 0 | 0 | 65535 | counts | Pass |
| $A4 - Misfire Cylinder 3 Data | TID $0C - Misfire counts for last/current driving cycles (calculated, rounded to an integer value) | 0 | 0 | 0 | counts | Pass |
| $A5 - Misfire Cylinder 4 Data | TID $0B - EWMA (Exponential Weighted Moving Average) misfire counts for last ten (10) driving cycles | 0 | 0 | 65535 | counts | Pass |
| $A5 - Misfire Cylinder 4 Data | TID $0C - Misfire counts for last/current driving cycles (calculated, rounded to an integer value) | 0 | 0 | 0 | counts | Pass |
| $A6 - Misfire Cylinder 5 Data | TID $0B - EWMA (Exponential Weighted Moving Average) misfire counts for last ten (10) driving cycles | 0 | 0 | 65535 | counts | Pass |
| $A6 - Misfire Cylinder 5 Data | TID $0C - Misfire counts for last/current driving cycles (calculated, rounded to an integer value) | 0 | 0 | 0 | counts | Pass |
| Description | Value |
|---|---|
| Vehicle Identification Number | YV1MS382852078311 |
| Calibration ID - $10 | 0030788260AC |
| Calibration ID - $10 | 0030729523A |
| Calibration Verification Number - $10 | D2396C0D |
| Calibration Verification Number - $10 | C6FAD955 |