3d printed mini cable clips, my solution to the "not enough USB charging" issue
#1
3d printed mini cable clips, my solution to the "not enough USB charging" issue
I know there are some other solutions to this as well. This was mine. It was relatively fast and cheap. Not sure if I should be posting it here or somewhere else. In any event, here they are. They were much better than the gaffers tape I tried initially. Plus they keep everything in an easy-to-remove state.
The model is available for free on Thingiverse.
http://www.thingiverse.com/thing:2456019
If anyone is interested, I'd be willing to print some for say $1ea or so.
The model is available for free on Thingiverse.
http://www.thingiverse.com/thing:2456019
If anyone is interested, I'd be willing to print some for say $1ea or so.
Last edited by marvinmartianx; 07-27-2017 at 04:58 PM.
Thread
Thread Starter
Forum
Replies
Last Post