D6 330 - Princess V39
#1
D6 330 - Princess V39
Hi, anybody encountering this problem ?
I have a Princess V39, 2014 model with 2 x volvo penta d6, 330hp
Both drives are fully done at -6.
Port drive shows an alarm and Trim monitor displays wrongly that Port drive is in breach position and monitor shows a reading 56 whilst the drive is down.
Drive does not lift or lower from the helm. Only STB drive moves.
Tried replacing trim sensor but problem persists.
Tried trim calibration reset but problem persists.
Tried switching PCU and EVC module but problem persists.
I have a Princess V39, 2014 model with 2 x volvo penta d6, 330hp
Both drives are fully done at -6.
Port drive shows an alarm and Trim monitor displays wrongly that Port drive is in breach position and monitor shows a reading 56 whilst the drive is down.
Drive does not lift or lower from the helm. Only STB drive moves.
Tried replacing trim sensor but problem persists.
Tried trim calibration reset but problem persists.
Tried switching PCU and EVC module but problem persists.
Thread
Thread Starter
Forum
Replies
Last Post