Hi, I'm new to this forum and looking for some advice. I have a Volvo V70, 54 plate, 2.4 Turbo and Auto petrol. when i bought the car it would start but take a while to catch and run a bit lumpy for a few seconds, then idle no problem.After scanning the vehicle for the first time the codes i got were fuel pressure faulty signal, fuel pressure signal too low and fuel pressure signal missing. As soon as I drove the car and accelerated it would start to splutter and die. I initially changed the fuel pump control module by the tank but it made no difference. I then noticed that the in tank pump was noisy and have now changed this for a genuine Bosch part. The car now runs and drives perfectly but the EML is still on and now the codes are fuel pressure signal missing and fuel pressure signal too high. So after seeing these codes I have now fitted a genuine Bosch rail pressure sensor and fitted a brand new fuel filter and the codes are still there. After all of this i have noticed that when changing the fuel pressure sensor on the rail, when i went to release the petrol out of the little valve there wasn't anything in there. Is there something I am missing? or any other possible solutions in fact any help at all would be appreciated.