Between this site and tbrick ive found all I think ill need to swap, however, ive run across something I can't find info about. There is a coolant line running from my water pump towards rear of the block on pass side that preventing me from bolting on my Turbo. The manifold will not clear it nd its not flexible. If I didn't think it'd melt I'd consider cutting it and re routing it with flexible hose. I'm just stuck for the moment. Can't quite see where it leads and not yet familiar enough with these cars. Any help would be greatly appreciated. How necessary is this line and where does it go?

 

Okay heater core line. So now I'm looking for ideas. Could not see that's it turned onto rubber hose right behind block.