Clearing Fault Codes w/ OBD1
Thread Starter
Joined: Dec 2004
Posts: 10
Likes: 0
From:
Clearing Fault Codes w/ OBD1
Am trying to clear the SRS codes on my '93 850. I inserted the test lead into socket 5 in side "B", turned ign sw to "on" position and depressed the test button on Side "A" for at least 10 seconds. Upon releasing the button, the light didn'tcome ON. Per the instructions I have, it should come on and stay on.
Any suggestions on what problem is??
Thanks,
Tom
Any suggestions on what problem is??
Thanks,
Tom
Last edited by rspi; Jun 6, 2013 at 01:06 PM. Reason: typo
Senior Member
Joined: Sep 2006
Posts: 1,181
Likes: 0
RE: Clearing Fault Codes w/ OBD1
Hm.........
From what I read/heard, a light should come on after pressing the button for 6-7 seconds. After that light, you go 6-7 seconds again.
Perhaps clean the connections is all I can think of. My OBD-I port is messed up too...
From what I read/heard, a light should come on after pressing the button for 6-7 seconds. After that light, you go 6-7 seconds again.
Perhaps clean the connections is all I can think of. My OBD-I port is messed up too...
Administrator
Joined: Sep 2004
Posts: 36,349
Likes: 45
From: Orlando, Florida
Thread
Thread Starter
Forum
Replies
Last Post
