No start condition - starter cranks no ignition
Thread Starter
|
Junior Member
Joined: Feb 2017
Posts: 5
Likes: 0
No start condition - starter cranks no ignition
After having the PCV system replaced, the 2.5t Turbo with will not start. The starter cranks, the timing belt spins, the water pump and accessory belt spins but the engine does not start. There is pressure in the fuel bar, check with the schrader valve. There is no spark in at the plugs. I Ann it sure if fuel
is coming out of the injectors. I have checked all of the connections to ETC, MAF, fuel
injectors, thermostat, TPC valve, cam sensor and crank sensor. Triple checked all
vacuum hoses.
batter has been charged to 100%
tried resetting ECM with disconnected battery
replaced plugs with Volvo plugs
replaced cam sensor
Any Help would be appreciated
is coming out of the injectors. I have checked all of the connections to ETC, MAF, fuel
injectors, thermostat, TPC valve, cam sensor and crank sensor. Triple checked all
vacuum hoses.
batter has been charged to 100%
tried resetting ECM with disconnected battery
replaced plugs with Volvo plugs
replaced cam sensor
Any Help would be appreciated
Thread Starter
|
Junior Member
Joined: Feb 2017
Posts: 5
Likes: 0
compression test
Today I hooked up the OTC Conpression Kit to each of the 5 cylinders, after disconnecting the fuel injectors and coil packs to the plugs. When I pulled each plug they were wet and smelled like gasoline.
The Compression on each was 150psi..
The Compression on each was 150psi..
Thread
Thread Starter
Forum
Replies
Last Post
nightmarevolvo
Volvo 240, 740 & 940
20
Feb 4, 2023 06:20 PM
Cleaner13
Volvo 850
11
May 25, 2014 11:53 PM
