Shop repair manual
#9
Is VADIS anygood?
Well I finally had time to install VADIS. It took two hours to load onto my laptop and then only after trial and error, certainly not by following the limited instructions did I even get into VADIS.
Anyways, I could not find anything that would help me for the suspension work that I have planned, i.e. replacing the lower control arms and ball joints. I will probably wing it on my own, but it would have been nice to have for reference.
Most definately I will have the front end aligned in a shop.
Is this manual any good for this type of repair or am I experiencing PEBKAC?
Pebkac defined: an IT term used when the "Problem Exist Between Keyboard And Chair.
Thanks for your help.
Don
Anyways, I could not find anything that would help me for the suspension work that I have planned, i.e. replacing the lower control arms and ball joints. I will probably wing it on my own, but it would have been nice to have for reference.
Most definately I will have the front end aligned in a shop.
Is this manual any good for this type of repair or am I experiencing PEBKAC?
Pebkac defined: an IT term used when the "Problem Exist Between Keyboard And Chair.
Thanks for your help.
Don
#10
#11
I just ordered the Haynes manual from here:
http://www.themotorbookstore.com/9781844257935.html
Will post again to this thread after I get it and see how good it is.
http://www.themotorbookstore.com/9781844257935.html
Will post again to this thread after I get it and see how good it is.
#12
I just ordered the Haynes manual from here:
http://www.themotorbookstore.com/9781844257935.html
Will post again to this thread after I get it and see how good it is.
http://www.themotorbookstore.com/9781844257935.html
Will post again to this thread after I get it and see how good it is.
#13
That's what I was hoping for when I ordered it. Seems like the UK S60 is basically the same car as the North America car with just a few more engine choices, including diesel.
Thread
Thread Starter
Forum
Replies
Last Post
ouyangcui
Volvo S40
4
05-02-2007 05:05 PM