Limp Mode - Y Reg 2.4
Hey Chaps,
Car had like an orange warning light on the other day so got it scanned and the guy said it recommended a throttle body clean, so this was removed, cleaned and replaced, then on the way home my car went into limp mode and is now stuck in it? Throttle body has been back off and re-fitted to make sure everything has been aligned correctly.
Any ideas? I original thought is was just a lambda sensor issue but obviously not!
If I could get it out of limp mode I will be happy.
Thanks
Car had like an orange warning light on the other day so got it scanned and the guy said it recommended a throttle body clean, so this was removed, cleaned and replaced, then on the way home my car went into limp mode and is now stuck in it? Throttle body has been back off and re-fitted to make sure everything has been aligned correctly.
Any ideas? I original thought is was just a lambda sensor issue but obviously not!
If I could get it out of limp mode I will be happy.
Thanks
Just an update, not codes on the machine, engine management light cleared, been told it now has a miss-fire and to change the plugs, machine did say there's an air leak but didn't say where?
Suggestions?
Suggestions?
Thread
Thread Starter
Forum
Replies
Last Post




