Volvo V50 A sports wagon that is affordable, sporty and best of all, useful for almost anything.

Cabin filter replaced -- I hoped it to be like V70

Old Jul 19, 2017 | 05:40 PM
  #1  
urdrwho's Avatar
Thread Starter
|
Senior Member
Joined: Sep 2013
Posts: 509
Likes: 2
Default Cabin filter replaced -- I hoped it to be like V70

I want to replace my cabin filter because I don't know how old it is so I went looking to see where it is located and how to do it.

I was hoping that it would be easy like the V70

Apparently it is a crawl on the floor, twist, turn, pull and looks more of a pita than my S60.


Too hot to be crawling around Sigh!
 
Reply
Old Jul 19, 2017 | 06:13 PM
  #2  
ES6T's Avatar
Super Moderator
Joined: Oct 2010
Posts: 5,517
Likes: 73
Default

It's a lot easier to just remove the accelerator pedal rather than try to fight around it.
 
Reply
Old Jul 19, 2017 | 08:11 PM
  #3  
urdrwho's Avatar
Thread Starter
|
Senior Member
Joined: Sep 2013
Posts: 509
Likes: 2
Default

Good idea. To the rescue again --- yay. Not going out to look but how hard is it to get the pedal off?

Originally Posted by ES6T
It's a lot easier to just remove the accelerator pedal rather than try to fight around it.
 
Reply
Old Jul 19, 2017 | 09:56 PM
  #4  
AutoNaut's Avatar
Senior Member
Joined: Oct 2009
Posts: 750
Likes: 3
From: MD
Default

Yes, remove the accelerator. It is still a PITA but easier. There are 3 nuts holding the accelerator in place. I also remove the knee panel under the steering wheel. There are 3 screws that hold it in place. You will need to remove the panel just behind the center stack too. This just unsnaps. The reason I remove these is it gives a little more room but mainly so I can clean the air sensor for the climate control. It is snapped into the knee panel. Use a can of compressed air to gently blow the dust out. This can make a big difference in the function of the climate control.
 

Last edited by AutoNaut; Jul 19, 2017 at 10:03 PM.
Reply
Old Jul 19, 2017 | 10:02 PM
  #5  
ES6T's Avatar
Super Moderator
Joined: Oct 2010
Posts: 5,517
Likes: 73
Default

Just three 10mm nuts. As long as the studs don't break free from the bracket, its not bad. If you have a 1/4" air ratchet that fits up there, its easier. Or 1/4" electric ratchet. I've also used my 3/8" cordless impact with an extension and 10mm swivel. Usually takes about 2 minutes for me so give yourself 20 if using hand tools.
 
Reply
Old Jul 20, 2017 | 07:26 AM
  #6  
urdrwho's Avatar
Thread Starter
|
Senior Member
Joined: Sep 2013
Posts: 509
Likes: 2
Default

What the heck! Early and I've only had one cup of coffee --- may not yet be in a good mood. But -- possibility of bolts breaking off, removing knee panels, gas pedals, etc. All this to replace a cabin filter? I lived many years without one and the reason I want to change the filter is because I read that a clogged filter lowers efficiency of AC.

It isn't that the job is a hateful job but the need to bend and fold to remove and install a filter seems to be bad engineering.

The V70 in the video of my original post is a much better engineered filter location. The only negative could be (maybe) the possibility of it getting wet easier?

I can do our Honda in my suit.

 

Last edited by urdrwho; Jul 20, 2017 at 07:30 AM.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
debargha
Volvo S60 & V60
2
Feb 24, 2015 10:46 PM
nigel_miguel
Volvo S40
8
Jan 7, 2012 05:09 PM
bluemagicbus
Volvo XC90
3
May 17, 2011 07:18 AM
edahlgren
Volvo S80
7
Oct 21, 2010 06:24 PM
Ahmed
Volvo S80
5
Mar 28, 2008 04:22 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 12:44 AM.