Picture - 1993 Volvo 850 GLT
Hey now,
How about a shot or two of the real deal?
Show us The Real Toy [sm=badbadbad.gif]
Ya know ya wanna!!!
[sm=icon_cheers.gif]
[IMG]local://upfiles/14053/BF33536701D443C58E60DA2D08D9FEC7.jpg[/IMG]
How about a shot or two of the real deal?

Show us The Real Toy [sm=badbadbad.gif]
Ya know ya wanna!!!
[sm=icon_cheers.gif]
[IMG]local://upfiles/14053/BF33536701D443C58E60DA2D08D9FEC7.jpg[/IMG]
Hey now,
Thanks
. It's what I got and so far it works ok.
Funny thing though. It stalled on me today and I'm wondering what the funk is up with that
. I got a little bothered by it as I was just pulling into traffic when it stalled out, leaving a few drivers shaking their heads [:@]. Sorry 'bout that.
Well, I guess it's time to pull some codes and see what's wrong this time around. Starting with the ignition system. [8D]
It took a while but I did, finally, find a Hayne's Manual for the '94 850 and I plan on putting it to use again tomorrow as I have to look at a faulty ABS sensor, see how difficult it might be to remove, take a look under the front end as an inspection and finally wash, wax, mask, prep mouldings/bumpers and take my time painting everything including the mud guards.
I'll take before and after pic's and hopefully show a nice change.
Cheers!
Thanks
. It's what I got and so far it works ok.Funny thing though. It stalled on me today and I'm wondering what the funk is up with that
. I got a little bothered by it as I was just pulling into traffic when it stalled out, leaving a few drivers shaking their heads [:@]. Sorry 'bout that.Well, I guess it's time to pull some codes and see what's wrong this time around. Starting with the ignition system. [8D]
It took a while but I did, finally, find a Hayne's Manual for the '94 850 and I plan on putting it to use again tomorrow as I have to look at a faulty ABS sensor, see how difficult it might be to remove, take a look under the front end as an inspection and finally wash, wax, mask, prep mouldings/bumpers and take my time painting everything including the mud guards.

I'll take before and after pic's and hopefully show a nice change.
Cheers!
Welcome Billy850.
For QB a little reading material:
1.http://www.matthewsvolvosite.com/cha...ic.php?p=31221
2.http://www.volvoclub.org.uk/tech/ser...ionControl.pdf
The Anvil looking nice, I would be tempted to put on some lowering springs.
For QB a little reading material:
1.http://www.matthewsvolvosite.com/cha...ic.php?p=31221
2.http://www.volvoclub.org.uk/tech/ser...ionControl.pdf
The Anvil looking nice, I would be tempted to put on some lowering springs.
Thread
Thread Starter
Forum
Replies
Last Post




