HELP: pistons
#1
HELP: pistons
okay, does anybody know how much power my 94 850t's pistons can handle?
i'm looking to build a compound turbo stup(13g and hx40 feeding each other) when i go to wyotech this year. The only part holding me back is engine internals. Anyone with info please post. Bottom end has been honed by p/o maybe bored. idk. but i did a full head rebuild a few months back. i plan on doing rods, arp studs, and bearings.
thanks
jess
i'm looking to build a compound turbo stup(13g and hx40 feeding each other) when i go to wyotech this year. The only part holding me back is engine internals. Anyone with info please post. Bottom end has been honed by p/o maybe bored. idk. but i did a full head rebuild a few months back. i plan on doing rods, arp studs, and bearings.
thanks
jess
Last edited by holset850; 04-18-2010 at 11:43 AM.
#5
Only a small price to pay in the long run. A lot cheaper than blowing up your motor. I'll be saving my current motor after the swap and will rebuild it over time so I can use the 19T to it's full potential.
http://volvospeed.com/vs_forum/index...h-beam-rod-gb/
http://volvospeed.com/vs_forum/index...h-beam-rod-gb/
Thread
Thread Starter
Forum
Replies
Last Post