Replaced HID headlamp & ballast and got error message
#1
Replaced HID headlamp & ballast and got error message
Yo yo yo,
I installed one used HID / adaptive headlight and ballast because mine was ruined from condensation (2012 s60). I'm now getting an error message on the dashboard which states HEADLAMP FAILURE. SERVICE REQUIRED. The replacement headlamp light is on....its working.
Does anyone know a way around this? Is this a calibration issue?
I installed one used HID / adaptive headlight and ballast because mine was ruined from condensation (2012 s60). I'm now getting an error message on the dashboard which states HEADLAMP FAILURE. SERVICE REQUIRED. The replacement headlamp light is on....its working.
Does anyone know a way around this? Is this a calibration issue?
#2
I installed one used HID / adaptive headlight and ballast because mine was ruined from condensation (2012 s60). I'm getting message HEADLAMP FAILURE. SERVICE REQUIRED. The replacement headlamp light is on....its working.Does anyone know a way around this? Is this a calibration issue?
I trust if you reinstall your old headlamp the warning goes away - If so - transfer all of the electronics from your old unit - to the new one.
#3
#4
As a general rule is you cannot program a used module to work on another car - so your best bet is to transfer the electronics (if possible) from the old unit to the new unit.
A company such as xemodex can reprogram some used modules - but i'm not sure about a headlamp module .
A company such as xemodex can reprogram some used modules - but i'm not sure about a headlamp module .
Thread
Thread Starter
Forum
Replies
Last Post
Steve volvo xc60
Volvo XC60
4
05-03-2022 07:49 PM
twistab4pudd
Volvo S60 & V60
14
01-05-2011 08:53 PM
llcoollam
Volvo S60 & V60
3
04-24-2006 06:54 PM