Broke bolt torqing p. plate! help
#1
Broke bolt torqing p. plate! help
I was replacing the clutch on my 81 240 and on the final torquing of the pressure plate bolts I managed to snap off the head of one of the bolts. The head came clean off, and the rest is stuck in the flywheel. Should I just remove the flywheel and drill it out, and then re-thread it? Any ideas?
#2
#3
RE: Broke bolt torqing p. plate! help
ORIGINAL: Beardog
Remove the fly wheel so that you have access to the bolt. Try a small bolt puller first, before you rethread it. Drill a small hole and then use the smallest puller you have. hopefully you drill straight so that you don't have to rethread.
Remove the fly wheel so that you have access to the bolt. Try a small bolt puller first, before you rethread it. Drill a small hole and then use the smallest puller you have. hopefully you drill straight so that you don't have to rethread.
Thread
Thread Starter
Forum
Replies
Last Post
lmchle
General Volvo Chat
8
04-27-2009 07:17 PM