I need help, i installed a volt and boost gauge in my s70 but i cant find anywhere to let me know where i can install the sensor to get correct oil pressure. Anybody has done this?

 

The OEM on is on the front of the motor.

 

Hey any chance you can put up a pic? Is it attached to the oil pan?

 

This is not the best picture but the arrow points to the sensor.

 

AWSUM, thanx so much

 

sorry this is totally old, but say i take out that sensor and i simply screw in the the aftermarket for the guage will anything pop up? or does a wire connect to that sensor? i need to do this right now but dont know how to go about doing it!

 

The oil light will always be on. Unless you find a Y fitting and run the gauge and sensor off the same main port.

 

yea i was told to do the Y fitting

however what is the size i would need for that Y fitting to be? and what size is the sensor for that adapter?
i know that the oil pressure sender is 1/8" NPT thread

 

Sorry but I do not know the size off hand and do not have a sensor home to check.

 

ahhh i needa figure this out so when i replace PCV i can get an eeasy access to it right away!

 

This is one of the best post about oil pressure sensor instalation.
I've spent 3 moths to find something good.

Thank you for post.

Also i recommend How Does Oil Pressure Sensor Work - Where To buy