85 740 turbo manual cluch, slave & cluch problem
Thread Starter
|
Junior Member
Joined: Nov 2010
Posts: 1
Likes: 0
85 740 turbo manual cluch, slave & cluch problem
Help ! I'm helping a friend fix a slave cylinder problem ( it blew out that's not the problem ) the problem is when I replaced the slave and bled the system it doesn't have the stroke length to engage the throwout bearing, its as though the fork has moved out of position...Is there a web site I can go to that would show me where the problem might be...its a simple enough installation is there a trick to this 
contact me @ tmetros59@yahoo.com
contact me @ tmetros59@yahoo.com
Thread
Thread Starter
Forum
Replies
Last Post