clutch slave cylinder
#1
clutch slave cylinder
Hello everybody,
[1987 740 turbo, M46 manual transmission]
Well, my clutch pedal goes to the floor with no resistance. Tried bleeding the slave cylinder, but no luck. So, I'm going to replace the slave cylinder. My question is, it's not inherently obvious how the rear end of the slave cylinder connects to the clutch fork. I don't see any obvious fasteners.
How do you release the tail end of the slave cylinder from the clutch fork?
Thanks.
[1987 740 turbo, M46 manual transmission]
Well, my clutch pedal goes to the floor with no resistance. Tried bleeding the slave cylinder, but no luck. So, I'm going to replace the slave cylinder. My question is, it's not inherently obvious how the rear end of the slave cylinder connects to the clutch fork. I don't see any obvious fasteners.
How do you release the tail end of the slave cylinder from the clutch fork?
Thanks.
Last edited by fredbyte; 07-28-2009 at 08:18 PM. Reason: add photos
Thread
Thread Starter
Forum
Replies
Last Post