so everything is working now, dash feels amazing!! no more noise!!

only thing is that the SRS light is still on, how would i go about getting that cleared?

thanks!!

 

You need to find someone or a shop that can read and clear the codes.

Congrats on the good job!

 

Thanks for the day to day help! and the write up you made!

doubt i would have been able to finish it haha or would have just taken a week longer.

 

Your welcome!

 

I have the small screw in place through the hole at the top right above the 18 MM Bolt. But now that that's "pinned" there, I can't remove the steering wheel - UNLESS - I unplug the green connector on the back of the horn/airbag part of the wheel.
Is that what I'm supposed to do now? Unplug the green connector after it's pinned to the ... hole?
(Are we just pinning that orange cable to the 'steering column', and it says behind without the wheel when you remove the wheel?)

PS: by this: "Also after the screw is removed it is a good idea to use a marker and make a line from the steering wheel to the center shaft to mark the wheel for putting it back on"

-do you mean, mark under the 18mm bolt where the outer part of the spline would line up/meet the inner spline? So you put it back in the 'exact' same place/rotation later?

Thanks for any help tech.

 

Been awhile since i took it off but you should make the wheel where it connects, its going to be * (star) looking. so just make the rivets up so when your put the wheel back on it slides in the same position it was in before

hope that helps any..

 

Yes you have to unplug the air bag. The screw will hold the contact reel from spinning.
Yes mark under the 18MM screw.