Can't get my 1984 volvo 240 gl started
#21
on a volvo k-jet the fuel distributor is kinda buried under the intake manifold and not nearly as obvious as it is on Mercedes or VWs with K-Jet... the eaesier thing to see is if the injectors are on a rail and have wires running to them, then its definitely LH.
1990 Mercedes 300E KE-Jet ...
(shiny clean fuel distributor and airflow meter because I'd just taken it all apart, cleaned the distributor and replaced the fuel meter).
1990 Mercedes 300E KE-Jet ...
(shiny clean fuel distributor and airflow meter because I'd just taken it all apart, cleaned the distributor and replaced the fuel meter).
#22
on a volvo k-jet the fuel distributor is kinda buried under the intake manifold and not nearly as obvious as it is on Mercedes or VWs with K-Jet... the eaesier thing to see is if the injectors are on a rail and have wires running to them, then its definitely LH.
1990 Mercedes 300E KE-Jet ...
(shiny clean fuel distributor and airflow meter because I'd just taken it all apart, cleaned the distributor and replaced the fuel meter).
1990 Mercedes 300E KE-Jet ...
(shiny clean fuel distributor and airflow meter because I'd just taken it all apart, cleaned the distributor and replaced the fuel meter).
#23
early LH didn't have a valve, you need a T-fitting, and remove the incoming fuel hose, install the T, and connect the fuel pressure gauge to the T, then start the fuel pumps. if the engine is running, you need to disconnect the manifold vacuum line temporarily from the fuel pressure regulator to get the correct reading of 36 +/- 2 PSI.
#24
if you have a fuel rail, you have LH Jet not K Jet.
early LH didn't have a valve, you need a T-fitting, and remove the incoming fuel hose, install the T, and connect the fuel pressure gauge to the T, then start the fuel pumps. if the engine is running, you need to disconnect the manifold vacuum line temporarily from the fuel pressure regulator to get the correct reading of 36 +/- 2 PSI.
early LH didn't have a valve, you need a T-fitting, and remove the incoming fuel hose, install the T, and connect the fuel pressure gauge to the T, then start the fuel pumps. if the engine is running, you need to disconnect the manifold vacuum line temporarily from the fuel pressure regulator to get the correct reading of 36 +/- 2 PSI.
#25
Thread
Thread Starter
Forum
Replies
Last Post
autoxray
Volvo 850
11
03-16-2011 09:19 PM